Skip to content

Research-based guide

How to Steam Milk on a Breville Bambino (Step by Step)

Steam silky milk on a Breville Bambino: wand position, the vortex, when to stop at 140-149°F, purging, and fixes for weak steam. From Breville’s US manual.

Reader-supported. If you buy through links on this page, we may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. It never changes what we recommend. How this works

The short answer

Set the Bambino’s steam wand tip 3/4 inch below the milk, near the right side of the jug, and press STEAM. When the milk spins, lower the jug slightly to add air. Then sink the tip and keep it spinning until the jug is hot to touch (140–149°F, per Breville). Stop, wipe and purge.

Last updated: November 15, 2026 · By The Brew List editorial team · Research-based guide built from Breville’s US instruction books, not hands-on tested (see How we researched this)

Quick reference

StepWhat Breville’s Bambino manual says
Wand positionTip 3/4 inch (1–2 cm) below the surface, near the right-hand side of the jug, “at a 3 o’clock position”
StartPress the STEAM button
Stretch (add air)Once the milk spins clockwise, slowly lower the jug so the tip reaches the surface
TextureKeep the tip at or slightly below the surface, maintaining the vortex, until you have enough volume
HeatLift the jug to sink the tip, keep spinning; done at 140–149°F (60–65°C), “when the jug is hot to touch”
StopPress any button; wait for the steam to stop fully before removing the wand
CleanWipe with a damp cloth, then purge (hold STEAM for 3 seconds)

Source: Breville Bambino US instruction book.

What you need

  • A Breville Bambino (BES450). Breville includes a stainless steel milk jug in the box.
  • Fresh, cold milk. The Bambino Plus manual says to “start with fresh cold milk.” The Bambino manual doesn’t say, but the same advice applies.
  • A damp cloth for the wand.
  • Optional: a thermometer while you learn what “hot to touch” feels like.

Breville’s manual covers pulling the shot and steaming as separate steps, so do one, then the other. If your shots need work, start with our Bambino dial-in guide.

How to steam milk on a Breville Bambino: step by step

  1. Fill the jug. Pour cold milk into the supplied stainless steel jug. Breville’s Bambino manual doesn’t give a fill level. The Bambino Plus jug has MIN and MAX marks, and a common rule for an unmarked jug is to fill to just below the bottom of the spout so there’s room for the milk to expand.
  2. Position the wand. Lift the steam wand and insert it into the milk with the tip about 3/4 inch (1–2 cm) below the surface. Hold it close to the right-hand side of the jug, at the 3 o’clock position, as Breville describes.
  3. Start steaming. Press the STEAM button. Keep the tip just under the surface until the milk is spinning clockwise and forms a vortex (whirlpool).
  4. Add air. With the milk spinning, slowly lower the jug. Breville says this brings the tip to the surface and “start[s] to introduce air into the milk.” Gently break the surface with the tip to keep the milk spinning fast.
  5. Build volume. Keep the tip at or slightly below the surface and keep the vortex going until you have enough volume. Common barista practice is to add less air for a latte and more for a cappuccino. Breville describes the range as “silky smooth latté to creamy cappuccino.”
  6. Heat it through. Lift the jug so the tip sinks below the surface while the milk keeps spinning. Breville says the milk is at the correct temperature, 140–149°F (60–65°C), when the jug is hot to touch.
  7. Stop the steam. When the milk is nearly where you want it, press any button to stop. Breville warns that the steam “can’t stop immediately” and needs a few seconds, so wait until it has fully stopped before you take the jug away.
  8. Wipe and purge. Wipe the wand and tip with a clean damp cloth. Then point the wand at the drip tray, away from you, and press STEAM to run steam through it, or hold STEAM for 3 seconds to start the purge. Breville says the purge runs “short water pulses” through the wand and that both cup buttons blink while it runs.
  9. Pour. Tap the jug on the counter and swirl it to keep the milk glossy, then pour into your espresso. This step is common practice, not from Breville’s manual.

How hot should milk be for a latte?

Breville’s Bambino manual targets 140–149°F (60–65°C). It says you’ve reached it “when the jug is hot to touch.” That’s hot enough for most drinks without scalding the milk. If you’re unsure, use a thermometer for your first few jugs, then go by feel. Breville also warns that a finished drink can be about 194°F (90°C) in the cup, so handle it with care.

Why is my Bambino steam wand weak?

Breville’s troubleshooting table lists four causes of “small steam”:

  • The water tank is empty. Fill it.
  • The tank isn’t fully seated. Push it down completely to lock it in place.
  • The machine needs descaling. Run the clean & descale cycle. See how to descale a Breville Bambino.
  • The steam wand is blocked or almost blocked. Clean the tip (below).

A pulsing or pumping sound while steaming is, per Breville, “the normal operation of the pump,” so no action is needed.

How do I clean the Bambino steam wand?

After every jug, wipe the wand with a damp cloth and purge it. If the holes in the tip get blocked, Breville says frothing performance drops. Try a manual purge first. If the steam is still very weak, unscrew the steam tip with the steam tip cleaning tool and use the tool’s pin to clear the holes. The tool is stored under the water tank. Rinse the tip, screw it back on and purge again.

What about the Bambino Plus?

The Bambino Plus does it for you. Fill its jug between the MIN and MAX marks, set it on the drip tray over the temperature sensor so the milk covers the wand tip, choose a milk temperature and foam level, and press STEAM. Breville says texturing “will stop automatically when the selected milk temperature is reached.” Lowering the wand starts an automatic purge. Breville also says to use only the supplied stainless steel jug on this machine.

You can still steam manually on the Plus, using the same 3 o’clock technique as the Bambino. If you’re choosing between the two machines, see Bambino vs Bambino Plus.

Where to buy

FAQ

Can the Breville Bambino make latte art milk?

Yes. Its manual steam wand lets you control how much air goes in and how long the milk spins. Breville describes the range as “silky smooth latté to creamy cappuccino.” Latte art takes practice: aim for small, even bubbles and a glossy surface.

Where should the steam wand be in the jug?

Breville says to place the tip 3/4 inch (1–2 cm) below the surface, close to the right-hand side of the jug, at the 3 o’clock position. That angle helps the milk spin clockwise into a vortex.

How do I know when the milk is done?

Breville’s manual says the milk is at the right temperature, 140–149°F (60–65°C), when the jug is hot to touch. Stop a moment early, because the steam takes a few seconds to stop fully.

Why does my Bambino keep steaming after I press the button?

That’s expected. Breville’s manual warns that the steam “can’t stop immediately” and needs a few seconds to stop completely. Keep the wand in the milk until it does.

Can I steam oat or other plant milks?

Breville’s Bambino manual doesn’t cover plant milks. Many barista-style plant milks are made for steaming. Expect them to behave differently from dairy and check the carton’s guidance.

How often should I purge the steam wand?

After every use. Breville recommends running steam through the wand after milk texturing to reduce blockages, or holding STEAM for 3 seconds for the purge cycle.

How we researched this

This guide is research-based. We haven’t tested it hands-on yet. The steps, temperatures and troubleshooting come from Breville’s US instruction books for the Bambino (BES450, USCM M26) and the Bambino Plus (BES500, USCM Q21), checked November 15, 2026. Prices come from breville.com and seattlecoffeegear.com that day. Tips that aren’t in Breville’s manuals (fill level for an unmarked jug, more air for cappuccino, swirling before pouring) are labeled as common barista practice.

Sources: Breville Bambino US instruction book (BES450 USCM M26); Breville Bambino Plus US instruction book (BES500 USCM Q21); breville.com BES450 and BES500 product pages; seattlecoffeegear.com Bambino and Bambino Plus listings.

Related: How to dial in espresso on a Bambino · How to descale a Breville Bambino · Bambino vs Bambino Plus · Single wall vs dual wall baskets · Espresso at Home hub

How we research

Our guides are built from manufacturer specs, manuals, retailer data and long-term owner reports. Every claim is linked to its source. When we haven’t used something hands-on, we say so. No brand can pay for a placement. More about The Brew List

Newsletter · Fridays

The Brew List weekly deals.

One short email. The best coffee gear discounts of the week, checked against price history so a “sale” is really a sale.

Get the list

  • Only genuine price drops
  • Gear for every budget
  • Unsubscribe in one click

We’ll only use your email to send the newsletter. See our Privacy Policy.